Locate a Distributor
Select Your Province:

Unique to Mitsubishi Electric, our heat recovery technology uses just two pipes, as opposed to the market conventional three. Designed for effective simultaneous heating and cooling, our R2 and WR2 systems offer substantial savings on installation and annual running costs.


Flexibility and efficiency are key factors when selecting a heat recovery system. For example, while a heat pump system is adequate for a large open-plan office, an office that has a more partitioned structure will require the need to simultaneously heat or cool different sections of the office according to each user's individual preferences. The efficiency of this type of system comes from the ability to use the by-products of cooling and heating to transfer energy where it is required, thus acting as a balanced heat exchanger achieving up to 20% cost savings over a conventional heat pump system. The number of connection sites needed for a R2 / WR2 system are also significantly lower than those needed for a three pipe version. This helps to reduce installation costs, further increasing the savings associated with CITY MULTI.

The BC controller houses a liquid/gas separator, allowing the outdoor unit to deliver a mixture (2 phase) of hot gas for heating and liquid for cooling, all through the same pipe. Three pipe systems allocate a pipe to each of these phases. When this mixture arrives at the BC controller, it is separated and the correct phase delivered to each indoor unit depending on the individual requirement of either heating or cooling.