Overview

The High-speed Hand Dryer combines a stylish design, convenience, cost-performance, and new wave-shaped nozzles for a satisfyingly quick and quiet user experience. Two models are available: one equipped with a heater for extra comfort and speed; a heater-less model with reduced power consumption.

New Slim TypeMini Type
Rapid dryingInstantly warm heaterHygienic designLong service lifeErgonomic design
Hyper-nozzle
Approx. 3-5sec. hyper-nozzle

Mitsubishi Electric's proven Dual Jet engineering is now complemented with a streamlined nozzle design that provides an optimum balance between airflow rate and air volume, further enhancing efficiency and drying hands in a matter of seconds.

*1: JT-SB116JH (High, Heater ON)

*2: JT-SB116EH (Heater ON)

*3: Drying time: When the remaining water is 50 mg or less

Wave-shaped Nozzles

Innovative wave-shaped nozzles are introduced, reducing the amount of noise generated by the airflow dispensed from the jets. Coupled with an original fluid-control technology, extremely efficient low-noise operation has been achieved.

Previous model

Eddy generated with straight nozzle outlet flows easily, becoming a source of noise.

New model

Eddy generated with curved nozzle outlet. Less eddy generated, resulting in quieter operation.

Air-speed and Heater Setting Switches Included

There is a choice of two airflow speeds: "High" for prioritized drying and "Standard" for low-noise operation. The heater can be switched on or off.

*The setting switches are located inside the main unit, and can only be set at the time of installation.

Mode Drying time Operating noise* Power consumption
HIGH Approx. 9~11sec. Approx. 61dB 1250W
STANDARD Approx. 11~13sec. Approx. 58dB 1090W

* JT-SB116JH used with heater turned on and at factory default settings. Measurements performed in an anechoic chamber at a distance of 78 3/4" (2m).